Fire Sprinkler Systems

In your New Jersey, Delaware or Philadelphia building, your fire sprinkler system is the single most important fire protection system you can have. Fire sprinkler systems respond to fires in seconds, often putting them out completely or at least knocking them back until the fire department arrives. There are many different type of fire sprinkler system available, each one designed to protect a different type of building. At Confires, we provide full fire sprinkler installation – from piping and fire sprinkler head installation to electrical and plumbing hookups. If necessary, we can even install new water main and sewer lines or construct a new pump room in your building!

At Confires, we can install any type of fire sprinkler system in your building, including:

Wet Pipe Fire Sprinkler Systems – the most commonly used type of fire sprinkler, wet pipe fire sprinkler systems are a type of sprinkler system that uses automatic sprinkler heads attached to a piping system that comes pre-charged with water from the fire pump. With this type of fire sprinkler system, the fire sprinkler heads open in response to heat and water is discharged instantly after the heads open.

Wet pipe fire sprinkler systems are commonly found in typical office buildings and provide a standard level of fire protection.

Dry Pipe Fire Sprinkler Systems – a dry pipe fire sprinkler system uses fire sprinkler heads that are attached to pipes filled with pressurized air as opposed to water. When the sprinkler heads open, the gas is released and a valve is opened allowing pressurized water to flow through the pipes and out the open sprinkler heads. While this causes a slight delay in water discharge, it is useful in buildings where water could freeze if kept in the pipes.

Dry pipe fire sprinkler systems are less common than wet pipe fire sprinkler systems because they are more expensive and more complicated. However, they are very useful in certain situations, such as in unheated buildings, parking garages and refrigerated coolers where temperatures get cold enough that water could freeze in the fire sprinkler pipes.

Deluge Fire Sprinkler Systems – a deluge fire sprinkler system uses open fire sprinkler heads attached to a piping system which is itself connected to a water supply by a valve. When the smoke or fire alarm goes off, this valve open and sends water through the pipes and sends water through all of the sprinkler heads at once. Deluge fire sprinkler systems are used in applications where fires could spread quickly unless large quantities of water are delivered as quickly as possible.

Pre-Action Fire Sprinkler Systems – pre-action fire sprinkler systems are basically a combination of a deluge fire sprinkler system and a wet pipe fire sprinkler system – water enters the pipes via a valve and flows through the sprinkler heads when they are activated by heat. They are commonly used in spaces containing expensive and valuable equipment that could be damaged by the accidental triggering of the sprinklers.

No matter what kind of building you need to protect, there is a fire sprinkler system for you and Confires can install it. If you need to install a wet pipe, dry pipe, deluge or pre action fire sprinkler system in your New Jersey, Delaware or Philadelphia building, call Confires today!